Macpower Alumni Manual de instrucciones descargar pdf (Pagina 23)

SVAT ELECTRONICS

now you can see

CLEARVU11

MAIN MENU

MOTION DETECTION

The Clearvu11 has bulit in motion detection available for each camera . Press ENTER or +/- to check/uncheck this

item. The default setting is “” - checked.

MOTION SETTINGS

This is the link used to setup the motion settings for this camera. Press ENTER on Settings to call up Motion Setup

menu for the camera.

MOTION SETUP

In Camera Setup, press ENTER to

call up Motion Setup as shown

when the highlighted option is

Settings in the motion setup row

for the camera you wish to setup.

The Motion setup allows you to

dene how the system responds

to detected motion for the

selected camera.

Following is a brief description for each item and its specic operations:

• Duration – response duration to dene how long the DVR will record after motion is detected for this camera.

Press +/- buttons to adjust the value (3 seconds - 60 minutes, or discrete).

• Goto Preset – to dene the preset position to go to if motion is detected (only works with PTZ cameras). For

more details about preset locations, please refer to PTZ Control.

• Pre-record – will dene how long before motion is detected this camera will record at pre-record IPS. Press

+/- buttons to adjust the value (0-10 seconds, discrete). Please note that the actual pre-record time may be

shorter than the value set if the total size of the pre-record pictures exceeds the pre-record buer size of the

system.

• Post-record – will dene how long after motion is detected this camera will record at the set Event Record

IPS. Press +/- buttons to adjust the value (0 second - 60 minutes, or discrete).

• Alarm Out – will dene which Alarm Output will be triggered when motion of this camera is detected. Press

+/- buttons to select none (N/A) or one of the Alarm Outputs (1-2).

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 73 74

Sin comentarios

Macpower Alumni Manual de instrucciones Pagina 23